Securitron TSB-C Manual de usuario

Busca en linea o descarga Manual de usuario para Para Casa Securitron TSB-C. Securitron TSB-C User Manual Manual de usuario

  • Descarga
  • Añadir a mis manuales
  • Imprimir
  • Pagina
    / 3
  • Tabla de contenidos
  • MARCADORES
  • Valorado. / 5. Basado en revisión del cliente
Vista de pagina 0
Securitron Magnalock Corp. Tel 775.355.5625
550 Vista Boulevard Fax 775.355.5633
Sparks, NV 89434 [email protected]
www.securitron.com
© Copyright, 2010, all rights reserved P/N 500-24005
Page 1 Rev. B, 03/10
ASSA ABLOY, the global leader
in door opening solutions
DIRECT TSB-C MOUNT TO BAR END FOR THE DSB SERIES
INSTALLATION INSTRUCTIONS
1 DISASSEMBLE END OF BAR
1. Using a #1 Phillips head screwdriver,
remove the two screws and end cap.
2. Using a #2 Phillips head screwdriver, loosen
the bar end cover screws and remove the
shipping clip.
3. Carefully withdraw the end mount assembly
with the PC board from the end of the bar
making sure that the lever of the limit
switch (under the PC board) does not get
dislodged from the switch.
4. Using a #1 Phillips screwdriver, back out the two (2) screws to release the base riser from
the rest of the end mount assembly.
NOTE: These screws should remain in place (in the holes of the spring plunger housing
and end mount) This will help keep the plunger housing in place for time of
reassembly. (If the PC board and plunger assembly happen to come out of the end
mount, see procedure in step 4 for reassembly).
5. Place the end mount (with the PC board, plunger and screws) aside for reuse.
Shipping Clip
End Cap
& Screws
Bar End
Cover
Screws
End Mount
Assembly
PC Bo
Spring Plunger
Housing
PC Board
End Mount
Base Riser
Screws
- Loosen and
leave in place
through holes!
Vista de pagina 0
1 2 3

Indice de contenidos

Pagina 1 - INSTALLATION INSTRUCTIONS

Securitron Magnalock Corp. Tel 775.355.5625550 Vista Boulevard Fax 775.355.5633Sparks, NV 89434 [email protected]© Copyright, 2010

Pagina 2 - Page 2 Rev. B, 03/10

P/N 500-24005Page 2 Rev. B, 03/102 DRILL HOLE IN BASE RISER1. Determine which side of the base riser to feed the flexible door cord shield into.2. Scr

Pagina 3 - Page 3 Rev. B, 03/10

P/N 500-24005Page 3 Rev. B, 03/104 REASSEMBLE END MOUNT ASSEMBLYIF the PC board and plunger slide out ofthe end mount:1. Insert connector of power cor

Comentarios a estos manuales

Sin comentarios